TICALCS.net

OK< so here 's the deal......

I have a super big project due tomorrow, and my calc goes insane.fun.

When I attempt to do a regular screendump through TI ScreenCapture, when the calculator is on, plugged in and registering, it waits for awhile, then says:

"Cannot get screenshot"

This occurs with any piece of information
It reads the calculator as a T!-84 plus, but that is as far as it goes. Also, I'm not sure about this, but isn't your calculator supposed to stop blinking when it is plugged in? Mine does not.
I have tried: rebooting the device, unplugging cords, rebooting computer, checking files on TI for overfilled memory or bugs.
I have been deleting RAM and ARCHIVE files, so I might have deleted the necessary ones. Which ones are needed?
Any suggestions?

It's impossible to delete any critical files, so it's nothing you deleted.

It is not necessarily supposed to stop blinking when plugged in, only momentarily.

If what you need to take a screenshot of is not 84+ only, I suggest using an emulator of a TI-83/+ to take a screenshot. Here is a good one, and here is the file you should use as a ROM*. The readme is here. Maneuver to the correct screen, press Print Screen on your keyboard, paste it into Paint, and there.